1994 Mercury Capri Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Preliminary Test

Ensure battery is fully charged and is in good condition. If starter will not crank engine with fully charged battery, proceed with the following test.

  1. Connect positive voltmeter lead of DVOM to "S" terminal on starter solenoid. Connect negative lead to starter housing.
  2. Set ignition switch to START position, and observe voltmeter. If voltage at terminal "S" is greater than 8 volts, starter or circuit malfunction is indicated. See VOLTAGE DROP TESTΒ  and STARTER GROUND CIRCUIT TEST.
  3. If voltage is less than 8 volts at starter solenoid terminal "S", malfunction in circuit to terminal "S" is indicated. Proceed to the following tests.
NOTE: If the solenoid is extremely hot, it may not function even though voltage at the "S" terminal is 8 volts or more. Allow solenoid to cool and retest.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.