1993 Mercury Capri Base, StandardFACTORY OEM SERVICE PROCEDURE

Erasing Codes & Retesting

Erasing codes and retesting will give an indication of whether codes are hard or intermittent defects. Hard codes reset immediately and will be displayed during retest.

Disconnect negative battery cable. Press brake pedal for 5-10 seconds. Turn off VOM or Super Star II tester. Reconnect battery. Perform tests under RETRIEVING CODES to again display and record codes.

TROUBLE CODE DEFINITION

Service Code Fault Circuit & Pinpoint Test
01 Ignition Diagnostic Monitor IDMΒ 
02 (1) Crankshaft Position Sensor CPSΒ 
03 (2) Cylinder Identification Sensor CIDΒ 
06 (2) Vehicle Speed Sensor VSSΒ 
08 Vane Airflow Meter VAF
09 Engine Coolant Temperature Sensor ECT
10 Vane Air Temperature Sensor VAT
12 (2) Throttle Position Sensor TP
14 Barometric Pressure Sensor BP
15 Oxygen Sensor O2S
17 Oxygen Sensor O2S
25 (2) Fuel Pressure Regulator Control Solenoid FPRC
26 Canister Purge Control Solenoid CANP
34 Idle Speed Control ISC
Codes Not Listed Power & Ground Connections PGC
(1) Festiva only.
(2) Capri only.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.