Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Mercury Capri Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Steering Column: Description
NOTE:
Steering column is not repairable and must be replaced as a unit.
The steering column assembly consists of a steering shaft, steering shaft tube, upper and lower bearings, mounting brackets, ignition lock and combination switch assembly.
WARNING:
On models with Supplemental Restraint System (SRS), observe the following precautions. Before any repairs are performed, disconnect and shield battery ground cable and air bag back-up power supply. Back-up power supply is a Blue rectangular unit located behind glove box, attached to instrument panel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.