1983 Mercury LN7 RSFACTORY OEM SERVICE PROCEDURE

Fuel Injection System Specifications - PFI: Specifications

1.6L (EEC-IV) MPFI & SEFI SPECIFICATIONS

Application Specification
Manual Transmission
Throttle Position Sensor (TPS) Nonadjustable (0.6-1.1 volts) Optimum reading is .84 volts
Hot (Slow) Idle Speed (RPM) 800
Idle Speed Control Non-adjustable
Automatic Transmission
Throttle Position Sensor (TPS) Nonadjustable (0.6-1.1 volts) Optimum reading is .84 volts
Hot (Slow) Idle Speed (RPM) 750 Exc. Turbo models, Turbo models 800 RPM
Idle Speed Control Non-adjustable
2.3L TURBO (EEC-IV) MPFI & SEFI SPECIFICATIONS

Application Specification
Throttle Position Sensor (TPS) Nonadjustable (0.6-1.1 volts) Optimum reading is .84 volts
Hot (Slow) Idle Speed (RPM) 700-800
Idle Speed Control Non-adjustable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.