1983 Mercury Capri Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Air Temperature Sensor

Disconnect plug J1 from the ECA. Connect an ohmmeter between pins 8 and 12 of plug J1. Resistance should be 100-5000 ohms. If resistance is not correct, repair wiring harness or replace airflow meter. Check resistance between pin 8 of plug J1 and ground. If resistance is less than 10,000 ohms, a short to ground is present. Repair as necessary.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.