Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition System - TFI-IV: Operation
The TFI-IV distributor uses a Hall Effect switch mechanism to switch primary voltage and to trigger the discharge of high secondary voltage. Crankshaft position and engine load signal is supplied to the EEC-IV Electronic Control Assembly (ECA) to compute spark advance. Distribution of high secondary voltage is accomplished through a conventional cap, rotor, and spark plug wires.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.