Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Mercury Capri Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Relays
RELAYS LOCATION
| Component | Location |
|---|---|
| A/C Wide Open Throttle Cutout Relay (8-Cyl.) | Under left side of instrument panel, on shake brace. |
| Choke Relay | Right fender apron, near voltage regulator. |
| Dimmer Relay | Behind instrument panel, to right of steering column, on brace. See Figure. |
| Hazard Flasher Relay | Behind right side of instrument panel, above glove box. See Figure. |
| Starter Relay | Right fender apron, ahead of shock tower. See Figure & Figure . |
| Thermactor Air Diverter Timer Relay (6-Cyl.) | Above steering column, on shake brace. |
| Thermactor Dump Control Relay (8-Cyl.) | Under instrument panel, to right side of steering column. |
| Timer Relay | On right side of steering column support brace. See Figure. |
| Turn Signal Flasher Relay | Lower right corner of fuse box. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
