Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Mercury LN7 Automatic TransFACTORY OEM SERVICE PROCEDURE
Spark Plug Wire Resistance Check
- Remove distributor cap and disconnect spark plug end of suspected wire or wires. Connect ohmmeter leads to spark plug terminal and terminal inside distributor cap (each end of wire).CAUTION: Never puncture a spark plug wire when measuring resistance.
- If resistance is less than 5, 000 ohms per inch, visually inspect wires for damage and remove spark plug for inspection and/or replacement. If resistance is greater than 5, 000 ohms per inch, disconnect suspected wire from distributor cap and again connect leads to each end of wire.
- If resistance is now less than 5, 000 ohms per inch, inspect distributor cap and spark plug wire terminals for damage. Repair as necessary. If resistance is still greater than 5, 000 ohms per inch, replace wire(s).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
