Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1982CAPRI L6-200 3.3LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMDISTRIBUTORDISTRIBUTOR PLATE W/ PICK-UP SENSORSERVICE AND REPAIR
1982 Mercury Capri L6-200 3.3L
Distributor Plate W/ Pick-up Sensor: Service and Repair
1982 Mercury Capri L6-200 3.3LSECTION Service and Repair
Procedure
1. Remove distributor cap and rotor.
2. Remove vacuum advance unit and magnetic pickup assembly.
3. Remove attaching screws and lift base plate from distributor.
4. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.