Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mercedes Benz Metris Van CargoFACTORY OEM SERVICE PROCEDURE
Remove/Install Radar Sensor - AR30.30-S-1210E
Model 447
With Code JA6 (Active Brake Assist System)
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove front bumper | AR88.20-S-2000E | |
| 2 | Remove impact absorber (1) | ||
| 3 | Disconnect electrical connection (2) | ||
| 4 | Unlock latching (3) and remove collision warning system radar sensor (B162) | ||
| 5 | Install in the reverse order | ||
| 6 | Perform commissioning of the collision warning system radar sensor (B162) with diagnostic system | ||
| AD00.00-S-2000-04E | |||
| 7 | Read out fault memory; clear if necessary | ||
| AD00.00-S-2000-04E |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
