2017 Mercedes Benz GLS450FACTORY OEM SERVICE PROCEDURE

Remove/Install Injection System Control Unit - AR07.08-P-7008MLJ

ENGINE 157, 278 in model 166 

ENGINE 157, 278 in model 292 

Fig 1: Injection System/ME-SFI (ME) Control Unit Components Location - Engine 157, 278 In Model 166 (Shown On Engine 278)
G14133802Courtesy of MERCEDES-BENZ USA

Shown on model 166 with ENGINE 278 

NOTES Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Read out variant coding of the ME-SFI [ME] control unit (N3/10)    
REFER TO SELF-DIAGNOSTIC SYSTEMS   IMPORTANT When replacing ME-SFI [ME] control unit (N3/10)
IMPORTANT Connect up diagnostic system and read data from ME-SFI [ME] control unit (N3/10) in diagnostic system.
INSTALLATION IMPORTANT : Transfer stored data to new ME-SFI [ME] control unit (N3/10).
AD00.00-P-2000-04A
2 Remove ENGINE cover (3)    
3 Remove ME-SFI [ME] control unit (N3/10) with ball bearing of support (4) upwards out of the support (4) on intake manifold    
4 Detach connectors (2a, 2b) and detach from ME-SFI [ME] control unit (N3/10)    
5 Detach all supports (4) from ME-SFI [ME] control unit (N310) IMPORTANT When replacing ME-SFI [ME] control unit (N3/10)
TORQUE SPECIFICATION Ball head support to control unit
*BA07.08-P-1001-01A 
6 Install in the reverse order    
7 Perform sensor rotor adaptation with diagnostic unit IMPORTANT When installing new control unit ME-SFI N310
IMPORTANT Menu guidance:
ENGINE control unit
Adaptations
Teach-in processes
 
8 Release transport protection on ME-SFI [ME] control unit (N3/10) IMPORTANT When installing new control unit
ME-SFI N310
 
9 Personalize and activate ME-SFI [ME] control unit (N3/10) IMPORTANT When installing new control unit ME-SFI N310  
INSPECT Check     
DANGER Risk of accident  from vehicle starting off by itself when ENGINE running. Risk of injury  (bruises and burns) resulting from working on the ENGINE while it is being started or when it is running. Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. AS00.00-Z-0005-01A
10 Carry out an ENGINE test run    
CONTROL UNIT

Number Designation ENGINE 157, 278
BA07.08-P-1001-01A Ball head support to control unit Nm 4
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.