Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Limp-Home Mode, Function - GF07.10-P-1019OGF
ENGINE 642.8 in MODEL 166
as of model year 2016
ENGINE 642.8 in MODEL 292
Function requirements for engine limp-home mode, general points
- Circuit 87 (Engine management ON)
- Engine runs
Engine limp-home mode, general
The task of the engine limp-home mode consists of ensuring continued safe driving in the case of malfunctions on individual components of the engine management.
The CDI control unit (N3/9) controls engine limp-home mode based on the following signals:
- Camshaft Hall sensor (B6/1)
- Accelerator pedal sensor (B37), accelerator pedal position
- Crankshaft Hall sensor (B70), engine rpm
- Electronic Stability Program control unit (N30/4), brake actuation via chassis CAN 1 (CAN E1)
- Fully integrated transmission control unit (Y3/8n4), gear range via drive train CAN (CAN C)
Function sequence for engine limp-home mode
The function sequence is described in the following steps:
- Function sequence for limp-home mode for failure of the accelerator pedal sensor
- Function sequence for limp-home mode on failure of the crankshaft Hall sensor
Function sequence for limp-home mode for failure of the accelerator pedal sensor
In case of failure of a Hall sensor the system switches to a second Hall sensor and the engine power is reduced. To do this, the CDI control unit regulates the fuel pressure in the rails via the pressure regulating valve (Y74) and quantity control valve (Y94) and regulates the injection period by actuating the fuel injectors of cylinders 1 to 6 (Y76/1 to Y76/6). If the plausibility check made by the CDI control unit is negative or if both Hall sensors fail, the system will only work to regulate the idle speed.
Function sequence for limp-home mode on failure of the crankshaft Hall sensor
If no voltage signal is received from the crankshaft Hall sensor, the voltage signal from the camshaft Hall sensor will be used instead (for limp-home mode).
Diagnosis
Faults detected by the accelerator pedal sensor are stored in the fault memory and can be read out and cleared using Xentry Diagnostics.
| Electrical function schematic for torque coordination | PE07.10-P-2713-97NBD | ||
| Overview of system components for common rail diesel injection (CDI) | GF07.16-P-9997OGF |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
