Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Mercedes Benz GLS350dFACTORY OEM SERVICE PROCEDURE
Remove/Install Injection System Control Unit - AR07.08-P-7008OGR
ENGINE 642 in model 166, 292
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Read out variant coding with diagnostic system | When replacing the CDI control unit (N3/9) | |
| AD00.00-P-2000-04A | |||
| 2 | Remove wheel housing lining in the right fender | AR88.10-P-1321GQC | |
| 3 | Disconnect electrical connections on CDI control unit (N3/9) | ||
| 4 | Remove screw/bolts (3) and take CDI control unit (N3/9) out of bracket | ||
| 5 | Install in the reverse order | ||
| 6 | Read in variant coding with diagnostic system | When replacing the CDI control unit (N3/9) | |
| AD00.00-P-2000-04A | |||
| 7 | Start up CDI control unit (N3/9) using the diagnostic system | When replacing the CDI control unit (N3/9) | |
| AD00.00-P-2000-04A | |||
| Risk of accident from vehicle starting off by itself when ENGINE running. Risk of injury (bruises and burns) resulting from working on the ENGINE while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 8 | Carry out an ENGINE test run |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
