Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Mercedes Benz GLS350dFACTORY OEM SERVICE PROCEDURE
Remove/Install Injection System Control Unit - AR07.08-P-7008MLJ
ENGINE 157, 278 in model 166
ENGINE 157, 278 in model 292
Fig 1: Injection System/ME-SFI (ME) Control Unit Components Location - Engine 157, 278 In Model 166 (Shown On Engine 278)
Shown on model 166 with ENGINE 278
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Read out variant coding of the ME-SFI [ME] control unit (N3/10) | ||
| AD00.00-P-2000-04A | |||
| 2 | Remove ENGINE cover (3) | ||
| 3 | Remove ME-SFI [ME] control unit (N3/10) with ball bearing of support (4) upwards out of the support (4) on intake manifold | ||
| 4 | Detach connectors (2a, 2b) and detach from ME-SFI [ME] control unit (N3/10) | ||
| 5 | Detach all supports (4) from ME-SFI [ME] control unit (N310) | *BA07.08-P-1001-01A | |
| 6 | Install in the reverse order | ||
| 7 | Perform sensor rotor adaptation with diagnostic unit | ENGINE control unit Adaptations Teach-in processes |
|
| 8 | Release transport protection on ME-SFI [ME] control unit (N3/10) | ME-SFI N310 |
|
| 9 | Personalize and activate ME-SFI [ME] control unit (N3/10) | ||
| Check | |||
| Risk of accident from vehicle starting off by itself when ENGINE running. Risk of injury (bruises and burns) resulting from working on the ENGINE while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 10 | Carry out an ENGINE test run |
CONTROL UNIT
| Number | Designation | ENGINE 157, 278 | |
|---|---|---|---|
| BA07.08-P-1001-01A | Ball head support to control unit | Nm | 4 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
