2017 Mercedes Benz CLS400 BaseFACTORY OEM SERVICE PROCEDURE

Fuel Control DTCS (FSCM_EC)

FUEL CONTROL DTCS (FSCM_EC)

MB DTC Description
B210D-00 The power supply is too low.
B210E-00 The power supply is too high.
P0087-00 The fuel pressure in the system is too low.
P008A-00 The pressure in the fuel low pressure circuit is too low.
P0176-00 The fuel quality sensor has an electrical fault.
P0177-00 The fuel quality sensor has a malfunction.
P0178-00 The fuel quality sensor has a short circuit to ground.
P0179-00 The fuel quality sensor has a short circuit to positive.
P0461-00 The left fuel level sensor has a malfunction.
P0462-00 The left fuel level sensor has a short circuit to ground.
P0463-00 The left fuel level sensor has a short circuit to positive.
P0464-00 Component 'B4/2 (Right fuel level indicator sensor)' is sluggish or blocked.
P0627-00 The output for the fuel pump has an electrical fault or open circuit.
P0628-00 The output for the fuel pump has a short circuit to ground.
P0629-00 The output for the fuel pump has a short circuit to positive.
P062A-00 The output of the fuel pump is implausible.
P0A7C-00 The control unit 'combustion engine' has overtemperature.
P1240-00 The CAN bus has a malfunction.
P1611-00 The fuel pump has been switched off.
P162A-00 There is an internal fault in component 'Fuel pump'.
P2066-00 The right fuel level sensor has a malfunction.
P2067-00 The left fuel level sensor has a short circuit to ground.
P2068-00 The right fuel level sensor has a short circuit to positive.
P2069-00 Component 'B4/1 (Left fuel level indicator sensor)' is sluggish or blocked.
P2539-00 The pressure sensor of the low-pressure fuel circuit has a malfunction.
P2540-00 The signal for the pressure sensor of the low-pressure fuel circuit is implausible.
P2541-00 The pressure sensor of the low-pressure fuel circuit has a short circuit to ground.
P2542-00 The pressure sensor of the low-pressure fuel circuit has a short circuit to positive.
U0100-00 Communication with the control unit 'combustion engine' has a malfunction.
U0111-00 Communication with control unit "Battery" has a malfunction.
U0155-00 Communication with the instrument cluster has a malfunction.
U0168-00 Communication with the electronic ignition lock has a malfunction.
U0401-00 Implausible data were received from control unit 'combustion engine'.
U0427-00 Implausible data were received from the electronic ignition lock.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.