Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Mercedes Benz ML250FACTORY OEM SERVICE PROCEDURE
Remove/install O2 sensor - AR07.04-P-0080CD
ENGINES 651 in MODELS 166, 172, 204, 207, 212, 218, 221
| Remove/install | |||
| Risk of injury to skin and eyes caused by handling hot or glowing objects. | Wear safety gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Remove cylinder head cover trim | ||
| 2 | Remove air filter housing | AR09.10-P-1150CD | |
| 3 | Disconnect electrical connector (1) | ||
| 4 | Expose electrical wiring harness for oxygen sensor upstream of catalytic converter (G3/2) | ||
| 5 | Remove oxygen sensor upstream of catalytic converter (G3/2) | ||
| *BA14.00-P-1001-01F | |||
| Hot lubricating paste | *BR00.45-Z-1005-06A | ||
| 6 | Install in the reverse order | ||
| 7 | Connect STAR DIAGNOSIS, read out fault memory and erase if required | AD00.00-P-2000-04A | |
| Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. |
AS00.00-Z-0005-01A | |
| 8 | Carry out an engine test run and check exhaust system for leaks |
O2 SENSOR
| Number | Designation | Engine 651 | |
|---|---|---|---|
| BA14.00-P-1001-01F | O2 sensor to catalytic converter | Nm | 50 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1005-06A | Paste, hot lubrication 1 kg, DB supply specification 6879.20 | A 000 989 76 51 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
