2014 Mercedes Benz CL600FACTORY OEM SERVICE PROCEDURE

O2 sensors, location/task/design/function - GF07.04-P-4103M

ENGINE 275.950 in MODEL 215, 220 

ENGINE 275.951 in MODEL 230 up to Model Year 8 

ENGINE 275.953 in MODEL 216, 221 up to Model Year 8 

ENGINE 275.980 in MODEL 215, 220 

ENGINE 275.954 in MODEL 230 up to Model Year 8 

ENGINE 275.981 in MODEL 230 up to Model Year 8 

ENGINE 275.982 in MODEL 216, 221 up to Model Year 8 

ENGINE 285.980 in MODEL 240 

ENGINE 285.950 in MODEL 240 

Fig 1: Identifying Left/Right O2 Sensors And Catalytic Converter
G07537571Courtesy of MERCEDES-BENZ USA
O2 sensors, location   GF07.04-P-4103-02M 
O2 sensors, task Detecting the residual oxygen content in the exhaust and supplying a signal to the ME control unit.
O 2  sensor upstream of TWC (slave sensor): 
  • Lambda control
  • Self adaptation of the mixture formation
  • Functional chain tests

O 2  sensor downstream of TWC (master sensor): 
  • Two-sensor control
  • Monitoring of catalytic converter efficiency.
 
O2 sensor design   GF07.04-P-4103-03M 
O2 sensors function   GF07.04-P-4103-01M 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.