Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Correction programming, function - GF07.61-P-3031MAS
ENGINE 156.984 in MODEL 216.377, 221.077 /177 as of Model Year 09 /AEJ 08
Function requirements for correction programming, general points
- Circuit 15 ON (ignition ON)
- Circuit 87M ON (engine control ON)
Correction programming, general points
Different performance maps for the engine control can be stored and activated with correction programming in the ME-SFI [ME] control unit (N3/10).
Correction programming function sequence
Correction programming is carried out with "ignition ON" using the Diagnosis Assistance System (DAS) over the data link connector (X11/4).
The ME-SFI control unit is connected to the data link connector over the chassis CAN (CAN E) and diagnostic CAN (CAN D).
The following performance maps can be influenced (programming):
- Ignition maps for adaptation to different fuel grades (research o ctane n umber correction) (except code (494) USA version)
- Mixture maps for enrichment of the fuel/air mixture in different operating conditions (except code (494) USA version)
- Basic setting for idle speed
- Idle speed for engaged drive position
- Fault setting conditions for smooth running detection
| Electrical function schematic for correction programming | Model 216 | PE07.61-P-2782-97CAC |
| Model 221 | PE07.61-P-2782-97SAC | |
| ME-SFI [ME] control unit, component description | N3/10 | GF07.61-P-6000MAS |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
