2008 Mercedes Benz CL63FACTORY OEM SERVICE PROCEDURE

Correction programming, function - GF07.61-P-3031MAS

ENGINE 156.984 in MODEL 216.377, 221.077 /177 as of Model Year 09 /AEJ 08 

Function requirements for correction programming, general points 

  • Circuit 15 ON (ignition ON)
  • Circuit 87M ON (engine control ON)

Correction programming, general points 

Different performance maps for the engine control can be stored and activated with correction programming in the ME-SFI [ME] control unit (N3/10).

Correction programming function sequence 

Correction programming is carried out with "ignition ON" using the Diagnosis Assistance System (DAS) over the data link connector (X11/4).

The ME-SFI control unit is connected to the data link connector over the chassis CAN (CAN E) and diagnostic CAN (CAN D).

The following performance maps can be influenced (programming):

  • Ignition maps for adaptation to different fuel grades (research o  ctane n  umber correction) (except code (494) USA version)
  • Mixture maps for enrichment of the fuel/air mixture in different operating conditions (except code (494) USA version)
  • Basic setting for idle speed
  • Idle speed for engaged drive position
  • Fault setting conditions for smooth running detection
Electrical function schematic for correction programming Model 216 PE07.61-P-2782-97CAC
Model 221 PE07.61-P-2782-97SAC
ME-SFI [ME] control unit, component description N3/10 GF07.61-P-6000MAS 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.