Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Dynamic seat, function - GF91.25-P-0002T
MODELS 211.0/2/6 with CODE (433) Left dynamic seat, incl. multicontour seat with CODE (434) Right dynamic seat, incl. multicontour seat
Shown on model 211.0
Left side switch
Function prerequisites
- no undervoltage and overvoltage and
- no excess temperature and
- terminal 15R ON or
- circuit 15 ON
Function
The "dynamic seat" system is manufactured in a version for the left and a version for the right seat and includes:
- Filling and exhausting the air cushions of the multicontour seat according to the requirements that are read by the operating switch.
- Saving the actual contour and adjusting stored contours.
- Maintaining adjusted pressure values. The adjusted nominal pressures of the individual cushion areas are controlled continuously.
- The "dynamic lumbar support" function. Starting with the active air cushion the pulsation occurs alternately in both lumbar support duo cushions. After the program is finished, the original cushion pressure is restored. The pulsation occurs in pressure jumps of 50 hPa each, upwards or downwards. The residence time can be parameterized.
- A "vehicle dynamics seat" function, which combines the advantages of a comfortable seat with those of a sports seat. To do this, the lateral support during cornering is improved through an automatic pressure increase of the outside lateral support cushions.
In the
- seating area 1 cushion,
- lumbar support area 4 cushions (2 cushions each coupled),
- lateral area 2 cushions that are coupled with one another can be actuated in the hydraulic unit.
The air supply that is necessary to fill the seat cushions is provided by the pneumatic pump for dynamic seat control (M40/1). The adjusted contours can be stored.
| Manual filling/exhausting of the air cushions at the dynamic seat, function | GF91.25-P-2011T |
| Dynamic lumbar support via pulse switch at the dynamic seat, function | GF91.25-P-2012T |
| Dynamic lateral support at the dynamic seat, function | GF91.25-P-2013T |
| Position storage of the dynamic seat with memory, function | GF91.25-P-2014T |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
