2007 Mercedes Benz CLK63FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Splices

SPLICES LOCATION

Component Location
Z3/29z1 Top of engine.
Z3/29z2 Top front of engine.
Z3/31 Under left side of center console.
Z6/1 Left side of trunk.
Z6/8 In front SAM control module.
Z6/26 In front SAM control module.
Z6/27 In front SAM control module.
Z7/26 At base of right "A" pillar.
Z7/35 Top front of engine.
Z7/36 In front SAM control module.
Z7/46 Left rear of trunk.
Z20/62 Left rear wheelwell.
Z36/1 Right rear of trunk.
Z36/2 Right rear of trunk.
Z36/3 Left front wheelwell.
Z36/4 Left front wheelwell.
Z81 Behind left side of dash.
Z81/4 Under left side of center console.
Z85 In front SAM control module.
Z87/15 At right "C" pillar.
Z87/22 Near right rear wheelwell.
Z87/23 Near right rear wheelwell.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.