Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
O2 sensors, location/task/design/function - GF07.04-P-4103M
ENGINE 275.950 in MODEL 215, 220
ENGINE 275.951 in MODEL 230 up to Model Year 8
ENGINE 275.953 in MODEL 216, 221 up to Model Year 8
ENGINE 275.980 in MODEL 215, 220
ENGINE 275.954 in MODEL 230 up to Model Year 8
ENGINE 275.981 in MODEL 230 up to Model Year 8
ENGINE 275.982 in MODEL 216, 221 up to Model Year 8
ENGINE 285.980 in MODEL 240
ENGINE 285.950 in MODEL 240
| O2 sensors, location | GF07.04-P-4103-02M | |
| O2 sensors, task | Detecting the residual oxygen content in the exhaust and supplying a signal to the ME control unit. O 2 sensor upstream of TWC (slave sensor):
O 2 sensor downstream of TWC (master sensor):
|
|
| O2 sensor design | GF07.04-P-4103-03M | |
| O2 sensors function | GF07.04-P-4103-01M |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
