2007 Mercedes Benz CL600FACTORY OEM SERVICE PROCEDURE

ME-SFI lambda control, function - GF07.61-P-4022MOS

ENGINE 275.953 in MODEL 216.376, 221.176 as of Model Year 09 /AEJ 08 

ENGINE 275.982 in MODEL 216.379, 221.179 as of Model Year 09 /AEJ 08 

Exhaust gas conversion in the three way catalytic converter 

Fig 1: Identifying Three Way Catalytic Converter Exhaust Gas Conversion Characteristic Graph
G07537688Courtesy of MERCEDES-BENZ USA

Function requirements for lambda regulation, general points 

  • Circuit 87M ON (engine control ON)
  • Engine running
  • Coolant temperature >52 °C
  • Operating temperature reached in LH and RH O 2 sensors upstream of CAT (G3/3, G3/4)
  • Engine idling or partial-load range
  • Deceleration fuel shutoff not active.

Lambda regulation, general points 

The mixture composition is controlled within the narrowest limits around λ = 1 in order to achieve high conversion of the exhaust gases (exhaust gas conversion) in the catalytic converters. For this purpose, the ME-SFI control unit (N3/10) reads the following sensors:

  • Coolant temperature sensor (B11/4)
  • Charge air temperature sensor (B17/8) and pressure sensor downstream of throttle valve actuator (B28/7), engine load
  • LH and RH O 2 sensors upstream of CAT, oxygen sensor signals

Lambda regulation function sequence 

The O2 sensors upstream of the CAT react to the oxygen content in the exhaust and send the corresponding voltage signals to the ME-SFI control unit. This then regulates the mixture composition by adjusting the injection time of the fuel injection valves (Y62) so that λ=1 is reached. This process is repeated constantly (control loop).

The ME-SFI [ME] control unit alters the mixture composition with a time delay in order to prevent any risk of jerking.

Fig 2: Identifying Lambda Regulation Block Diagram
G07510393Courtesy of MERCEDES-BENZ USA

Example: 

Assuming a leaner fuel-air mixture is produced. This has the consequences that the oxygen sensor voltage drops and the ME-SFI control unit compensates for the leaner mixture by enriching it accordingly (extending the injection time).

This makes it possible to achieve a fuel-air mixture of approximately λ= 1.

The lambda control factor indicated with the Diagnosis Assistance System (DAS) changes towards +25 %.

The more the lambda control factor moves in the direction +25%, the leaner is the fuel-air mixture and the greater is the enrichment of the mixture on the part of the ME control unit.

Fig 3: Identifying Lambda Regulation Factor
G07510394Courtesy of MERCEDES-BENZ USA
REFER TO SYSTEM WIRING DIAGRAMS Electrical function schematic, lambda regulation ME Model 216 PE07.61-P-2774-97CAA
Model 221 PE07.61-P-2774-97SAA
  ME-SFI [ME] control unit, component description N3/10 GF07.61-P-6000MOS 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.