Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Mercedes Benz ML500FACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| AIRmatic With ADS Control Module | Under left front seat. |
| Booster Blower Electronic Blower Controller | In rear of center console. |
| Central Gateway Control Module | Under left front seat. |
| Emergency Call System Control Unit | Under left rear seat. |
| ESP Control Unit | Left front of engine compartment. |
| Front SAM Control Unit | Under right front seat. |
| Headlamp Range Adjustment Control Module | Under right front seat. |
| Keyless Go Control Module | Right rear of cargo area. |
| ME Control Unit (V6) | On top of engine. See Figure . |
| ME-SFI Control Unit | In right front footwell. See Figure . |
| PTS Control Module | Under left front seat. |
| Rear Axle Differential Lock Control Module | Under left rear seat. |
| Rear-End Door Closing Control Unit | Right rear of cargo area, under floor. |
| Rear SAM Control Unit | Right rear of vehicle. See Figure . |
| Restraints System Control Unit | Under center console. |
| SDAR Control Unit | Under left rear seat. |
| TPM [RDK] Control Module | Right rear of cargo area. |
| Transfer Case Control Module | Under right front seat. |
| Trip Computer Control Module | In front of roof. |
| WSS Control Unit (Weight Sensing System) | On right front seat frame. |
| Xenon Headlamp Control Module (Left/Right) | Behind respective headlamp. |
| Xenon Headlamp Ignition Module (Left/Right) | Behind respective headlamp. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
