2004 Mercedes Benz SLK32FACTORY OEM SERVICE PROCEDURE

Mode 6

NOTE: Mode 6 data is not available for all models. On-board diagnostic monitor ID definition for mode 6 applies to all modes. See Fig 1-Fig 12 .
MODE 6 DATA ME 2.8 (ENGINE 112 & 113)

Monitor ID Comp ID MIN MAX Test Value
01 01 ..... 67 2
01 02 ..... 67 4
01 03 ..... 83 3
02 01 ..... 450 70
02 02 ..... 450 69
03 03 15072 ..... 15100
03 04 15072 ..... 15100
04 05 6 ..... 22
MODE 6 DATA ME 2.8 AMG (ENGINE 112, 113, 155)

Monitor ID Comp ID MIN MAX Test Value
01 01 ..... 179 18
01 02 ..... 179 19
01 03 ..... 90 18
02 01 ..... 230 42
02 02 ..... 230 37
03 03 15072 ..... 15100
03 04 15072 ..... 15100
04 05 6 ..... 22
05 2F 0 ..... 0
05 2D ..... 0 0
05 25 ..... 0 0
09 01 ..... 47186 31607
09 01 18350 ..... 31607
09 03 ..... 32987 32742
09 03 32549 ..... 32742
09 02 ..... 47186 31912
09 02 18350 ..... 31912
09 04 ..... 32987 32751
09 04 32549 ..... 32751
Fig 1: On-Board Diagnostic Monitor ID Definition For Mode 6 - All Models (1 Of 12)
G00105202Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.