2004 Mercedes Benz SLK32FACTORY OEM SERVICE PROCEDURE

O2 sensor design - GF07.04-P-4103-03F

O 2  sensors upstream and downstream of TWC 

Finger sensor 

Fig 1: Identifying O2 Sensor Design Components - Finger Sensor
G04736506

Voltage-free insulated O2 sensors are used.

The active sensor ceramic consists of a gas-permeable ceramic body manufactured from zirconium dioxide. A protective tube with several slots protects the ceramic body from mechanical stresses and from temperature jumps.

The electrical connection is performed by means of a 4-pin connector.

The capacity of the sensor heater at operating temperature is:

  • 18 W (engines with ME 1.0, 2.0, 2,1)
  • 7 W (engine 112, 113 with ME 2.8, engine 137).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.