2004 Mercedes Benz SLK32FACTORY OEM SERVICE PROCEDURE

Correction programming function - GF07.61-P-3031F

ENGINE 104.941 as of 1.6.96 

ENGINE 104.943 /944 /991 /994 as of 1.6.95 

ENGINE 104.945/ 995 

ENGINE 111.921 /943 /944 /947 /951 /952 /955 /956 /957 /958 /973 /975 /972 /982 /983 

ENGINE 111.945 /961 /974 as of 1.8.96 

ENGINE 111.970 as of 1.5.96 

ENGINE 111.942 as of 1.9.98 

ENGINE 111.946 as of 1.6.98 

ENGINE 112.910 /911 /912 /913 /914 /916 /917 /920 /921 /922 /923 /940 /941 /942 /943 /944 /946 /947 /949 /953 /954 /955 /970 /972 /973 /975 

ENGINE 113.940 /941 /942 /943 /948 /960 /961 /963 /965 /966 /967 /968 /969 

ENGINE 119.980 /981 /982 /985 

ENGINE 120.982/ 983 

ENGINE 137.970 

ENGINE 166.940 /960 /990 /995 

ENGINE 166.960 with CODE (922) Power-reduced 

Fig 1: Correction Programming Function -- Engines 104, 111, 112, 113, 119, 120, 137, 166
G04738398

With the correction programming it is possible to activate different maps of the engine management system in the engine control unit.

The coding is performed with the Hand-Held Tester (HHT) or with STAR DIAGNOSIS. The following maps can be influenced:

  • Ignition maps for adapting to different fuel quality (except USA ONLY )
  • Mixture maps for enriching the fuel/air mixture in different operating states (except USA ONLY )
  • Idle speed on automatic transmission and engaged selector lever position
  • CO setting on models without TWC (except USA ONLY )
  • Fault setting conditions for rendering smooth operation identification less sensitive
  • Cylinder shutoff threshold (on engines fitted with cylinder shutoff)
  Motor electronics control unit, location/task/design/function other than engine 111 EVO GF07.61-P-5000F 
    Engine 111 EVO GF07.61-P-5000GS 
  HFM-SFI control unit, location/task/design/function Engine 104, 111 HFM-SFI GF07.51-P-4103D
  ECM control unit, location/task/design/function Engine 166 up to 08/01 (hot film mass air flow sensor and intake air temperature sensor integrated) GF07.53-P-4103GC
    Engine 166 as of 09/01 (throttle valve actuator integrated) GF07.53-P-4103GD
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.