Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check Toe Out On Turns: Checking
The toe-out on turns is measured to check the steering geometry. Toe-out on turns is the difference in the steer angle between the outside wheel and the inside wheel when the inside wheel is steered through 20 degrees. Check and adjust front axle toe-angle. Check toe-out on turns. If substantial deviations are found, the cause may be one of the following, assuming that the camber and caster settings are correct:
- Toe not adjusted with the rack-and-pinion steering in the straight-ahead position, resulting in tie rods of unequal length.
- Steering knuckle or tie rod bent.
- Vehicles with excessive deviations in the front end, may have accident damage.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.