2003 Mercedes Benz CLK430FACTORY OEM SERVICE PROCEDURE

On-Line SCN Coding Instructions Using XENTRY Flash. (58.00/144C)

Publication date: 2007-12-14
Reference number: 58.00/144C
Supersedes refnos: 58.00/144A, 58.00/144B

ON-LINE SCN CODING INSTRUCTIONS USING XENTRY FLASH.

ON-LINE SCN CODING INSTRUCTIONS USING XENTRY FLASH.

TECHNICAL SERVICE BULLETIN

Reference Number(s): S-B-58.00/144C, Date of Issue:  December 14, 2007
MERCEDES-BENZ: Mercedes-Benz Models
GROUP: 58 - Tools
Superceded Bulletin(s): S-B-58.00/144B, Date of Issue:  July 24, 2006

SUBJECT

ON-LINE SCN CODING INSTRUCTIONS USING XENTRY FLASH. 

NOTE: Information Only.

A. INTRODUCTION

This bulletin provides instructions on how to use the On-Line SCN Coding with the new Xentry Flash function of the STAR Diagnosis System which will be available with the release of DAS 11/07.

On-Line SCN Coding with Xentry Flash is designed to streamline the SCN Coding process by eliminating the need for a technician to transfer between Star Browser and DAS on the SDS.

On-Line SCN Coding can only be performed using a STAR Diagnosis System that has been networked and has access to the internet. For information on networking of the STAR Diagnosis System please refer to documents posting on STAR TekInfo under the Systems & Administration/SDS Tab titled: Phase (1,2,3) Letter Online SCN Coding.

B. OBTAINING ONLINE SCN CODING USER IDs

NOTE: Each technician must have their own User ID in order to perform On-line SCN Coding, User IDs and passwords are not to be shared.

To obtain an On-line SCN Coding User ID:

  • New User IDs must be obtained by filling out and signing the SCN Coding User ID Request Form and faxing the form to 1-201-573-4335. The new User ID will be emailed to the email address of the Service Manager provided by the requestor on the form.
NOTE: Passwords can be reset by the NetStar Helpdesk - 1-888-9 NetStar
  • The NetStar Helpdesk cannot grant new User IDs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.