2003 Mercedes Benz CLK430FACTORY OEM SERVICE PROCEDURE

Digital Tele Aid Control Module (82.95/535)

Publication date: 2006-12-21
Reference number: 82.95/535

DIGITAL TELE AID CONTROL MODULE

DIGITAL TELE AID CONTROL MODULE

TECHNICAL SERVICE BULLETIN

Reference Number(s): P-I-82.95/535, Date of Issue:  December 21, 2006
MERCEDES-BENZ: MODEL 208.465/470/474; MODEL YEAR 2001-2003
GROUP: 82 - Electrical System - Body

SUBJECT

MODEL 208.465/470/474 with SA CODE (801) 

MODEL YEAR 2001-2003 

DIGITAL TELE AID CONTROL MODULE 

SERVICE INFORMATION

WARNING: Do not disconnect the negative battery cable. Extensive reprogramming requirements are otherwise necessary. Wiring harnesses are therefore electrically active.

Severe vehicle damage, personal injury, or death from electrical shock could result.

Exercise extreme caution while executing these installation instructions. Keep the ignition and radio powered OFF through the final test.

Notes on D2B optical fibers

  • Optical fibers damage easily-handle optical fibers with care to prevent cuts, nicks, abrasions, and crushing.
  • Optical fiber "ring configurations" must form a closed loop to function (i.e. couple the input of a component with the output of the preceding component).
  • Identify D2B optical fibers by their orange, semi-rigid insulation.
  • Electromagnetic interference (EMI) from bundled vehicle electrical harnesses does not affect optical fibers.
  • The digital Tele Aid control module for vehicles equipped with ECALL2 has a D2B port. Do not connect the D2B port of the digital Tele Aid control module if the existing analog Tele Aid control module has no D2B port. Include the digital Tele Aid control module in the D2B ring configuration only if the existing analog Tele Aid control module has a D2B port.
MODEL SERIES REFERENCE

Model Series Tele Aid MY 01 MY 02 MY 03 MY 04 MY 05 MY 06
G04602348
EC2D  X X X      
  • Tele Aid Location:  Behind the Back Passenger Seats in the Trunk.
  • Estimated Physical Installation Time:  2.5 h
  • Opcode:  82-9621
Fig 1: Digital Tele Aid Control Module
G04602349

A. PREPARING FOR THE INSTALLATION

  1. Read these installation instructions in their entirety before proceeding.
  2. To get access to the unit, see WIS document AR82.95-P-0005D, "Removing and installing Tele Aid emergency call system control module" (do not remove the unit at this point).
  3. Plug the Star Diagnosis into the OBD Diagnosis Port. The OBD diagnostics port is a 38-pin port in the wiring harness compartment in the right, rear corner under the hood (Fig 2 and Fig 3 ).
    Fig 2: OBD Diagnosis Port Location
    G04602350
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.