2003 Mercedes Benz CLK430FACTORY OEM SERVICE PROCEDURE

Using Generic Scan Tool

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 Mercedes-Benz ML320, 2002 Mercedes-Benz E320, 2002 Mercedes-Benz CLK320, 2001 Mercedes-Benz ML320, and 2001 Mercedes-Benz E320. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Connect generic scan tool to diagnostic connector located under left side of dashboard. See Fig 1. Turn ignition on. Follow tool manufacturer's instructions for reading fault codes. If no fault codes are present, but vehicle is experiencing a problem, go to TROUBLE SHOOTING - NO CODES (ENGINE 112) article.

Fig 1: Locating Generic Scan Tool Diagnostic Connector
G97F06231Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.