Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mercedes Benz CLK430FACTORY OEM SERVICE PROCEDURE
DTC P1642: Me-SFI Control Module Incorrectly Coded: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 Mercedes-Benz ML320, 2002 Mercedes-Benz E320, 2002 Mercedes-Benz CLK320, 2001 Mercedes-Benz ML320, and 2001 Mercedes-Benz E320. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This trouble code is set because the ME-SFI control module was coded to a manual transmission when vehicle is equipped with an automatic transmission.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
