2003 Mercedes Benz CLK430FACTORY OEM SERVICE PROCEDURE

DTC Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 Mercedes-Benz ML320, 2002 Mercedes-Benz E320, 2002 Mercedes-Benz CLK320, 2001 Mercedes-Benz ML320, and 2001 Mercedes-Benz E320. However, it is still accessible from the selected car via links, so may be relevant.
  • Fault Memory & Actuation Of MIL -  After 2 consecutive driving cycles with fault.
  • Frequency Of Testing -  Continuous.
  • Checked Signal Or Status -  Calculated resistance value of sensor heater.
  • Lower Limit Value -  Less than 2 ohms.
  • Upper Limit Value -  More than 10 ohms.
  • Test Conditions -  Sensor heater on and heating-up time of approximately 220 seconds has elapsed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.