Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mercedes Benz CLK430FACTORY OEM SERVICE PROCEDURE
Lateral Acceleration Sensor
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 1999 Mercedes-Benz SLK230, 1999 Mercedes-Benz ML430, 1999 Mercedes-Benz ML320, 1999 Mercedes-Benz E430, and 1999 Mercedes-Benz E320. However, it is still accessible from the selected car via links, so may be relevant.
Lateral forces move internal spring/mass element (magnets) out of REST position into a position in relation to the Hall Sensor element which alters voltage signal informing ESP control module.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.