2003 Mercedes Benz CL55FACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application Specification Range
Caster (1)(2)
Except USA See Fig 4 ....
USA See Fig 5 ....
Front Axle Camber (3) See Fig 1 ....
Front Axle Toe-In (All) 0° 32' +/-10'
Front Axle Toe-Out On Turns (4)
Except USA 1° 41' +/-30
USA 1° 38' +/-30
Rear Axle Camber (5)(6)
Except USA See Fig 3 ....
USA See Fig 3 ....
Rear Axle Toe-In (7)
Except USA See Fig 2 ....
USA See Fig 2 ....
(1) Check caster, assign tabular value. Refer to illustration and match with a value in table.
(2) Check permissible difference in front caster between right and left side of vehicle.
(3) Measure front axle riding height. Check camber, assign a value. Refer to appropriate illustration.
(4) Toe-Out On Turns with inside wheel turned through 20 degrees.
(5) Rear Axle Camber and Caster, adjustment information is not available.
(6) Specifications given as information only.
(7) Check Toe-in at rear axle, assign tabular value. Refer to illustration and match with a value in table
Fig 1: Check & Adjustment Values For Front Axle Camber At Vehicle Level
G00305870Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Chapter Navigation
Return to Chapter: Wheel Alignment Specifications & Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.