2002 Mercedes Benz SLK320 AutomaticFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application Specification Range
Front Axle Camber (1) See Fig 1 & Fig 2 ....
Rear Axle Camber (2)(3) See Fig 3 ....
Front Axle Caster (4)(5) See Fig 4 ....
Front Axle Toe-In 0° 20' +/-10'
Rear Axle Toe-In (6) 0° 33' +/-7
Front Axle Toe-Out On Turns (7) -1° 25' +/-30
(1) Measure front axle riding height. Check camber, assign a value. Refer to appropriate illustration.
(2) Rear Axle Camber and Caster is not adjustable.
(3) Specifications given as information only.
(4) Check caster, assign tabular value. Refer to illustration and match with a value in table.
(5) Check permissible difference in front caster between right and left side of vehicle.
(6) Overall toe-in at rear axle.
(7) Toe-Out On Turns with inside wheel turned through 20°.
Fig 1: Front Axle Camber Specification
G00305935Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Chapter Navigation
Return to Chapter: Wheel Alignment Specifications & Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.