Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mercedes Benz SLK32FACTORY OEM SERVICE PROCEDURE
Charge air temperature sensor, location/task/function - GF07.04-P-5038H: Notes
ENGINE 112.960 in MODEL 170.466
ENGINE 112.961 in MODEL 203.065 /265
Illustrated: M112K, rear engine view, suction lines and air cleaner housing removed.
| Charge air temperature sensor position | At the charge air distribution pipe (110/1) in the V-angle of the engine below the throttle valve actuator (M16/6). | ||
| Charge air temperature sensor task | Measuring the charge air temperature. The signal (together with the signal of boost pressure) is used for calculating the air mass. In addition, the charge air temperature sensor (B17/8) monitors the operation of the charge air cooling system. | ||
| Charge air temperature sensor function | The function of the charge air temperature sensor (B17/8) is identical to the intake air temperature sensor (B17) in the engine M628. The NTC resistor which is installed in the charge air temperature sensor alters its ohmic resistance depending on the charge air temperature. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.