2002 Mercedes Benz S430FACTORY OEM SERVICE PROCEDURE

Adjustments Hints

  1. Loosen hex nuts on lower wishbone mount to adjust camber (front eccentric bolt) and caster (rear eccentric bolt). When tightening hex nuts, after adjustment, hold eccentric bolts. Tighten nuts to specification. See TORQUE SPECIFICATIONSΒ  .
  2. Check toe-in. Center steering wheel and install holder. Adjust to specifications. See WHEEL ALIGNMENT SPECIFICATIONSΒ  table. On vehicles with rack and pinion steering, ensure rubber boot on inner tie rod is not twisted.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.