Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mercedes Benz S430FACTORY OEM SERVICE PROCEDURE
DTC Description
- Fault Memory & Actuation Of MIL - After 2 consecutive driving cycles with fault.
- Frequency Of Testing - Continuous.
- Checked Signal Or Status - Correction value exceeded or cycle duration too long.
- Limit Values Of Correction Value - Approximately plus or minus 1.2 seconds.
- Period Of Limit Value - More than 5 seconds (average value from more than 15 measurements).
- Duration Of Test - Up to 190 seconds.
- Test Conditions - Engine speed approximately 1000-2000 RPM, engine load approximately 15-50 percent, TWC temperature more than 716°F (380°C), Lambda control enabled, no fault with TWC effect, and no fault with O2 sensor heating.
NOTE:
The period of the O2 sensor before TWC is too long; O2 sensor after TWC does not continue to be monitored. Correction value of O2 sensor before TWC exceeded; O2 sensor after TWC continues to be monitored. If faults for the O2 sensor before and after TWC are recognized at the same time; usually only the O2 sensor after the TWC is defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.