Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mercedes Benz G500FACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||
|---|---|---|---|---|
| Steering Angle Stop Screw Lock Nut | (1) | |||
| Steering Wheel-To-Steering Shaft Nut | 60 (80) | |||
| Drag Link Lock Nut | 103 (140) | |||
| Tie Rod Clamp Bolt | 40 (55) | |||
| Wheel Bolt | ||||
| Light Alloy Wheel | 95 (130) | |||
| Steel Disk Wheel | 132 (180) | |||
| Lug Nut | ||||
| Light Alloy Wheel | 110 (150) | |||
| Steel Disk Wheel | 132 (180) | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.