Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mercedes Benz G500FACTORY OEM SERVICE PROCEDURE
Testing Procedure
- CAN Data Bus - Connect DVOM between ME-SFI control module connector "D" terminal No. 11 and 12 (socket box terminals No. 43 and 44). Turn ignition off. Resistance should be 55-65 ohms. If resistance is within specification, go to next step. If resistance is not within specification, possible causes are Controller Area Network (CAN) failure. Go to next step.
- Turn ignition off. Disconnect ME-SFI control module connector "D". Connect DVOM between ME-SFI control module connector "D" terminals No. 11 and No. 12 (socket box terminals No. 43 and 44). Resistance should be 115-125 ohms. If resistance is within specification, go to next step. If resistance is not within specification, possible causes are wiring harness failure or defective infrared DAS control module (N54/1). Repair as necessary.
- Turn ignition off. Disconnect ME-SFI control module connector "D" from test cable (socket box) and reconnect to ME-SFI control module. Connect DVOM between ME-SFI control module connector "D" terminals No. 11 and No. 12 (socket box terminals No. 43 and 44). Resistance should be 115-125 ohms. If resistance is within specification, test is complete. If resistance is not within specification, possible cause is ME-SFI control module (N3/10) defective. Repair as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.