Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE
DTC Description
- Fault Memory & Actuation Of MIL - After 2 consecutive driving cycles with fault.
- Frequency Of Testing - Continuous.
- Checked Signal Or Status - Calculated resistance value of sensor heater.
- Lower Limit Value - Less than 4.4 ohms. Corresponds to approximately 2.7 amps at 12 volts.
- Upper Limit Value - More than 18.4 ohms. Corresponds to approximately 0.65 amps at 12 volts.
- Test Conditions - Engine running and sensor heater on and heating-up time of approximately 220 seconds has elapsed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.