Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mercedes Benz S430FACTORY OEM SERVICE PROCEDURE
Camshaft Hall Sensor (B6/1)
NOTE:
Manufacturer recommends checking camshaft hall-effect sensor signal using an oscilloscope. If an oscilloscope is not available, testing can be performed with a DVOM.
- Camshaft Hall-Effect Sensor Signal (Testing With Oscilloscope) - Connect oscilloscope between ME-SFI control module connector "E" terminals No. 39 and 40 (socket box terminals No. 95 and 96). Observe oscilloscope with engine idling. See Fig 1 .
- If oscilloscope pattern is okay, go to step 4 . If oscilloscope pattern is not okay, possible cause wiring harness failure or camshaft hall-effect sensor (B6/1) defective. Repair as necessary.
- Camshaft Hall-Effect Sensor Signal (Testing With DVOM) - Connect DVOM between ME-SFI control module connector "E" terminal No. 40 (socket box terminal No. 96) and ME-SFI control module connector "A" terminal No. 2 (socket box terminal No. 2). Observe DVOM with engine idling. Voltage should be 1.2-2.2 volts. Voltage will vary slightly. If voltage is not okay, possible causes are wiring harness failure or camshaft hall-effect sensor (B6/1) defective. Repair as necessary.
- Camshaft Hall-Effect Sensor (Voltage Supply) - Disconnect camshaft hall-effect sensor (B6/1) connector. Turn ignition on. Connect DVOM between camshaft hall-effect sensor (B6/1) connector (harness side) terminals No. 1 (Brown/Green wire) and 3 (Red/Blue wire). Voltage should be 11-14 volts. If voltage is within specification, test is complete. If voltage is not within specification, possible cause is wiring harness failure. Repair as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.