2001 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE

Checking Riding Height: Notes

NOTE: Riding height may also be referred to as vehicle level.

On this vehicle chassis an electronic inclination measuring instrument (CM-9606) must be used to measure front and rear vehicle level (riding height). See Fig 1 and Figure . It is necessary to check vehicle riding height using a servicing pit or alignment rack. Vehicle weight must be on wheels. See instrument manufacturer for tool usage.

NOTE: The measuring plate (086b) is magnetic, information on data media, e.g. floppy disks, credit cards, etc, could be rendered unusable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.