Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
AAM Module Inspection (DTB; MB-NET 081)
Reference number: DTB; MB-NET 081
AAM MODULE INSPECTION
TECHNICAL SERVICE BULLETIN
| MERCEDES-BENZ: | MODEL 163, MODEL YEAR 2001 |
| GROUP: | 54 - Electrical System |
SUBJECT
GROUP 54 - MODEL 163, MODEL YEAR 2001, AAM MODULE INSPECTION
SERVICE INFORMATION
In reference to DTB; MB-NET 079 dated February, 15, 2001, following is the repair information required during inspection / replacement of the AAM2 module.
- Step 1: Connect Star Diagnosis, under Control Units menu, select "Body", select "AAM", select "control unit version" (Reference AD00.00-P-2000-04A).
- Step 2: Observe displayed date code. Six-digit date code reads DD/MM/YY of production. Only AAM2 with date code between 08/01/01 and 29/01/01 are to be replaced. If date code does NOT fall within specified range, no further action is necessary. If date code falls within specified range, continue through the following steps.
- Step 3: Using Star Diagnosis, select "Control Unit Adaptations" under AAM menu. Select "read coding and transfer to the new control unit" to store coding data in Star Diagnosis. Follow on-screen instructions.
- Step 4: Remove covers of fuse and relay box (5 screws).
- Step 5: Unscrew and lift up fuse and relay module (F1) (2 screws). Do NOT bring any live cables into contact with ground.
- Step 6: Unplug four connectors and antenna on AAM2 (N10).
- Step 7: Remove AAM2. Be careful not to damage locking tabs. Insert wedge (115 589 03 59 00) between AAM2 and fuse and relay module to disengage locking tab at top center, release locking tab above connectors and simultaneously push AAM2 away from fuse and relay module.
- Step 8: Install replacement AAM2. Be careful not to bend connector pins.
- Step 9: Transfer stored AAM2 data from Star Diagnosis to new AAM2. Follow on-screen instructions.
- Step 10: Using Star Diagnosis, select "learn radio code of a new transmitter key" to learn RF keys to new AAM2. Follow on-screen instructions.
- Step 11: Repeat for all RF keys.
- Step 12: Install removed components in reverse order.
- Step 13: Perform function test.
AAM2 (N10) Control Module - Part No. 163 545 53 32
WARRANTY INFORMATION
| Damage Code | Operation Code | Time Allowance | Model Indicator (s) |
|---|---|---|---|
| 54960 31 | 02 3410 - Inspect only; no replacement of AAM2 | 0.4 hours | K0 |
| 54960 31 | 02 3411 - Inspect and replace AAM2 | 1.0 hours | K0 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
