2001 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE

Procedure B

WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2000 Mercedes-Benz SLK230, 2000 Mercedes-Benz SL500, 2000 Mercedes-Benz S500, 2000 Mercedes-Benz S430, and 2000 Mercedes-Benz ML55. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Connect pressure bleeding equipment according to equipment manufacturer's instructions and pressurize system to 29 psi (2 bar). Connect Hand Held Tester (HHT) to Data Link Connector (DLC) located in right rear of engine compartment. Turn ignition on. Follow instructions on HHT display. After performing instructions on HHT display, start bleeding procedure.
  2. Caliper bleeding sequence is RR, LR, RF and LF. Bleed approximately 1/10th of a quart of brake fluid from each brake caliper. Allow brake fluid to flow until no air bubbles are present. Remove pressure bleeding equipment and HHT. Verify master cylinder reservoir is at proper level.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.