Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Model Identification
WARNING: This page is about a different car, the 2002 Mercedes-Benz G500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Diagnostic information applies to 2002 G500 with 5.0L engine (No. 113), equipped with Motor Electronics Sequential Fuel Injection (ME-SFI). Diagnostic information in this article does not apply to all models with engine number 113. For diagnostic information availability, see MODEL IDENTIFICATION (2002)
table.
MODEL IDENTIFICATION (2002)
| Model | Chassis/Model Number | Engine Number | |
|---|---|---|---|
| 2002 | |||
| G500 | 463.249 | 113.962 | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.