Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Using Hand Held Tester (HHT)
Turn ignition off. Connect HHT to 38-pin diagnostic connector located in right rear of engine compartment. Turn ignition on. Follow manufacturer's instructions for reading fault codes. If no fault codes are present, but vehicle is experiencing a problem, go to TROUBLE SHOOTING - NO CODES (ENGINE 113 - EXCEPT G500) article.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.