Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Testing Procedure
Connect DVOM between ME-SFI control module connector "A" terminal No. 8 (socket box terminal No. 8) and ME-SFI control module connector "D" terminal No. 16 (socket box terminal No. 48). Turn ignition on. Voltage should be less than one volt. If voltage is okay, test is complete. If voltage is not okay, possible causes are wiring harness failure or check and diagnose trouble codes in air bag system. See appropriate AIR BAG RESTRAINT SYSTEMS article in lemon-25(R) AIR BAG SERVICE & REPAIR MANUAL, DOMESTIC & IMPORTED MODELS.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
