Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Test Procedure
- Voltage -
Connect DVOM between ME-SFI control module connector "E" terminals No. 48 and 45 (socket box terminals No. 104 and 101). Turn ignition on. Voltage should correspond with temperature. See INTAKE AIR TEMPERATURE SENSOR VOLTAGE
table. If voltage is okay, test is complete. If voltage is not okay, perform remaining step. Possible causes are defective ME-SFI control module (N3/10).INTAKE AIR TEMPERATURE SENSOR VOLTAGE
Temperature (1) Volts 50°F (10°C) 3.1 68°F (20°C) 2.7 86°F (30°C) 2.2 104°F (40°C) 1.8 122°F (50°C) 1.4 140°F (60°C) 1.1 (1) Voltage values can vary plus or minus 5 percent. - Resistance -
Turn ignition off. Connect DVOM between ME-SFI control module connector "E" terminals No. 48 and 45 (socket box terminals No. 104 and 101). Resistance should correspond with temperature. See INTAKE AIR TEMPERATURE SENSOR RESISTANCE
table. If resistance is okay, test is complete. If resistance is not okay, possible causes are wiring harness failure or defective hot film MAF sensor (B2/5). Repair as necessary.INTAKE AIR TEMPERATURE SENSOR RESISTANCE
Temperature (1) Ohms 50°F (10°C) 3600 68°F (20°C) 2420 86°F (30°C) 1660 104°F (40°C) 1170 122°F (50°C) 850 140°F (60°C) 600 (1) Resistance values can vary plus or minus 5 percent.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
